At present, more and more factories have installed exhaust gas treatment equipment, not only because of environmental regulations, but also because the legal representatives of factory owners deeply recognize the necessity of exhaust gas treatment. As a common waste gas treatment equipment, what issues should be paid attention to in the installation, operation, and use of the waste gas scrubbing tower.

1、 Overview of exhaust gas scrubbing tower

Exhaust gas scrubbing tower is a type of gas purification equipment. Widely used for industrial waste gas purification and pre dust treatment and purification, the treatment effect is very good, and many industries require the use of scrubbers for waste gas treatment. The washing tower consists of four parts, with the main frame consisting of the tower body and tray, reboiler, and condenser. During use, the reboiler usually uses steam heating, while the condenser uses circulating water for heat conduction. Before use, balance should be maintained inside the device. During repeated use, it is necessary to control the position of the liquid while maintaining two temperatures and two pressures within a certain range.

2、 What should be noted when installing a waste gas scrubbing tower

When installing the exhaust gas scrubbing tower, whether indoors or outdoors, it is necessary to protect the water pump and fan motor from the influence of rainwater or other liquids, in order to prevent electrical appliances from malfunctioning and malfunctioning due to moisture.

2. Check each component daily to ensure that the screws are not loose and the bearings are not damaged.

3. It is necessary to observe in a timely manner whether there are any debris entering.

3、 Precautions for using waste gas treatment scrubbing tower

Before using the exhaust gas treatment washing tower equipment, check whether the switch valves of each system of the equipment are intact and whether the proportion of absorbent is normal.

When using, the absorbent can only be used when it meets the specified requirements. When the dosage is insufficient, it should be replenished in a timely manner.

3. The water pump should start first, and the fan should start five minutes later.

When shutting down the exhaust gas treatment scrubber, the fan should be turned off for a few minutes before turning off the water pump at the same time. Otherwise, it will burn out the motor, block the packaging, and affect the air purification effect.

When using the exhaust gas purification washing tower, the connection line between the fan and the water pump cannot be changed arbitrarily. It should be ensured that their running direction is correct, clockwise direction is correct.

After the exhaust gas purification scrubber is put into use, the production unit should send professional personnel for regular maintenance and inspection. If any abnormalities are found, the machine should be stopped and repaired after parallel operation.

No matter where the exhaust gas scrubbing tower is installed, it should be well moisture-proof to prevent the equipment from working properly. At the same time, attention should be paid to whether there are debris inside and outside the bracket, which may cause the fan to malfunction or the impeller to explode and injure the staff.